Elenco Electronics FG-500K User Manual

FUNCTION GENERATOR KITMODEL FG-500KAssembly and Instruction ManualElenco Electronics, Inc.Copyright © 2000 Elenco Electronics, Inc. Revised 2001 R

-9-In each of the following steps, start with the switch and pots as shown on the previous page.2) OUTPUT WAVEFORMSConnect an oscilloscope probe to th

-10-FUNCTIONAL DESCRIPTIONThe FG-500 is a function generator integrated circuit capable of producing high quality sine, triangle, and squarewaves of h

-11-CONTROLSRANGE SWITCHESSix ranges of frequency are provided by the range switch as shown in Table 1.Table 1SINE/TRIANGLE SWITCHThis SINE/TRIANGLE S

-12-SCHEMATIC DIAGRAM

-13-QUIZ1) The heart of the FG-500 Function Generator is the _________ monolithic function generator integratedcircuit.2) The XR-2206 is comprised of

EMPTY PAGE

Elenco Electronics, Inc.150 W. Carpenter AvenueWheeling, IL 60090(847) 541-3800http://www.elenco.come-mail: [email protected]

PARTS LISTContact Elenco Electronics (address/phone/e-mail is at the back of this manual) if any parts are missing ordamaged. DO NOT contact your plac

-2-INTRODUCTIONAssembly of your FG-500 Function Generator will prove to be an exciting project and give much satisfication andpersonal achievement. Th

-3-IntroductionThe most important factor in assembling your FG-500K Function Generator Kit is good soldering techniques.Using the proper soldering iro

Figure BBend the capacitor over beforesoldering.-4-ASSEMBLE COMPONENTS TO THE PC BOARDCare must be given to identifying the proper components and in g

Figure Ea Figure EbMount the pot down flush with the PCboard. Solder and cut off excess leads.-5-ASSEMBLE COMP

Install the colored binding posts to the panel as shown in Figure I.Use the hardware shown in the figure. Make sure that the small nutis tight.WIRING

-7-Install the handle as shown in Figure L.Cut two pieces of weather stripping. Remove the protective backing and place a piece of weather strip onthe

-8-Attach the battery snap to the battery. Insert the PC board assembly with the panel and battery into the case(as shown in Figure L). Insert two 4-4